Nokia 7360 ISAM FX-16 - Figure 220 Ejector Handles for LT Cards; Figure 221 Ejector Handles for NT Cards

Installing cards in the 7360 ISAM FX-4 shelf
380
ANSI Hardware Installation Manual
3HH-12893-AAAA-TCZZA Issue: 09
DRAFT
Figure 220 Ejector handles for LT cards
Figure 221 Ejector handles for NT cards
5 Remove the card from its slot and place it in an ESD protective bag.
6 STOP. This procedure is complete.
Procedure 86 To change the NGFC-G card
Use the following procedure to change the NGFC-G card on the 7360 ISAM FX-4.
1 Before disconnecting the power cable, ensure power to the cables has been disconnected.
2 Remove the safety cover and power cable screws (loosen and remove the screws); see
Figure 222.
Withdrawl
Guiding plate
25830
33.77 in.
85.8 cm
22375
Warning — If the following steps to disconnect the power cables are
not followed exactly, there can be a possible fire hazard.