NSW-5
Service Software Instructions
PAMS Technical Documentation
Page 24
Issue 1 10/00
Nokia Mobile Phones Ltd.
Normal Mode
Activation Status Bar Text
Alt, P, I, N Initialises phone to normal (cellular) mode
F5
When normal mode has been activated or program has been started,
self–test results will be asked from MCU. If any fault was found in the
tests, an error message is shown. If normal mode has been set success-
fully (no self test error has been found), and paging listening has been
started, the used AFC value is requested from MS.
Initialisation routine checks phone’s cellular type and if unsupported
phone is detected, application unloads the DLLs.
The After Sales SW sets automatically the MS state to normal mode
when needed.
If phone identification view is open, window will be automatically updated.
Also if RF Information Window is open it will be updated to quick info
view.
L
ocal Mode
Activation Status Bar Text
Alt, P, I, L Initialises phone to local mode
Shift+F5
Selection will change the MS state to
local
. When user selects item from
Testing or Tuning menus, the After Sales SW software will change auto-
matically the MS state to local.
The After Sales SW sets automatically the MS state to normal mode
when needed.
Also if quick info view is open it will be updated to RF Information view.
F
aultlog command
Activation Status Bar Text
Alt, P, F
Opens a submenu. Only enabled when user has logged in.
To Next Page
Loading...
Need help?
General
