NSW-5
Disassembly and Troubleshooting Instructions
PAMS Technical Documentation
Page 47
Issue 1 10/00
Nokia Mobile Phones Ltd.
VHF VCO
The VHF VCO signal is used to generate transmitter Intermediate fre-
quencies. The VHF VCO has two fixed frequencies. Operating frequency
is locked in a Phase Locked Loop, which is controlled by baseband.
In AMPS and TDMA800 modes the VHF frequency is 322.38 MHz. In
TDMA1900 mode a higher intermediate frequency is needed, so the op-
erating frequency is increased to 392.46 MHz.
The VHF VCO output signal is fed to the EROTUS LO–pin VV_in. Inside
the EROTUS, the signal is divided for the Phase detector and TX parts.
Before injection to the I/Q–modulator, the frequency is divided by 2 .
To Next Page
Loading...
