Nortek 2GIG GC2 - Wiring; Remote Alarm Sounder

Installation
Copyright © 2016 Nortek Security & Control 15
Wiring
Hardwiredloopsneedtobeprogrammedforcontacttype.
Figure 6 Hardwired Loop Wiring
WARNING: Strandedconductorsclampedunderwire‐
bindingscrewsorsimilarpartsshallhavetheindividual
strandssolderedtogetherorarrangedinaconstruction
thathasbeendeterminedtobetheequivalent.
Remote Alarm Sounder
TheControlPanelprovidestwo(2)terminalsforanoptional
connectiontoaremoteelectronicalarmsounder.
Figure 7 Remote Alarm Sounder
WARNING: Toavoiddamagetotheoutput,doNOT
connectanelectromechanicalbelltotheseterminals.
Thebellterminalscanbesupervised.IfQ21:Siren
SupervisionTimeissetto(1)Enabled,andthewire
betweentheControlPanelandsounderiscut,theControl
Paneldisplaysatroublealertmessageforsirensupervision
andsendsabelltroublereporttotheCentralStation.
1 Installtheremotesounderinasecurelocationwhereit
willbeeasilyheardbyoccupants.
2 Routewiringfromtheremotesounderlocationtothe
ControlPanel’ swallcutout.
NOTE: Ifthepiezoalarmsirenfortheremotesounderhas
anextremelylowcurrentdraworthesounderproduces
humornoise,installan820Ωresistorinparallelwith
thesounder.