Nortek 2GIG GC2 - GSM (Cellular) Radio Module Installation

Installation
Copyright © 2016 Nortek Security & Control 17
See"WireSizeandLength"onpage20forwiresiz eand
maximumlength.
1 Runafour(4)‐conductortelephonecablefromthe
telephonecompany’sdemarcationpointtotheControl
Panelmountingplate.
2 Installthe2GIGGo!ControlPOTSModuleintothe
ControlPanel.
WARNING: Toreducetheriskoffire,useonlyNo.26AWG
orlargertelecommunicationlinecordforphoneline
communications.
3 Atthedemarcationpoint,dothefollowing:
3a Disconnectonlythehousetelephonesthatare
wiredtotheboxoutput.
Donotdisturbthetelcoinput“drop”sideofthebox
oranyearthgrounds.
3b ConnecttheREDcablewiretotheboxRing,and
theGREENcablewiretotheboxTip.
3c ConnecttheBLACKcablewiretothehouse
telephoneRingwire(s),andtheYELLOWcablewire
tothehousetelephoneTipwire(s).
4 AttheControlPanel,dothefollowing:
4a Connectthecable’sREDwiretotheRJ31Xjack’s
Ringinterminal,andtheGREENwiretothe
RJ31Xjack’sTipinterminal.
4b Connectthecable’sBLACKwiretotheRJ31Xjack’s
Ringoutterminal,andtheYELLOWwiretothe
RJ31Xjack’sTipoutterminal.
4c Snapthecoveronthejack.
4d Plugoneendofthemodularcableintothejackand
slideitthroughtheholeinthemountingplateinto
thewall.
5 PowerONtheControlPanel.
6 AccesstheSystemConfigurationscreenasfollows:
6a AttheHomescreen,tapthesystemlogointhe
lower‐rightcorner.
6b AttheEnterYourCodescreen,enterthemaster
installercode(thedefaultcodeis1561).
6c AttheInstallerToolboxscreen,tapSystem
Configuration.
6d TapGoToandthenenterthecodeshownbelowto
respondtotheseprogrammingquestions:
•Enter08.Fordetails,see"Q8:Dialer(0‐1)"on
page52.
•Enter11.Fordetails,see"Q11:CS#1Phone
Number(0‐25Digits)"onpage53.
•Enter12.Fordetails,see"Q12:CS#1Account
Number(4Digits)"onpage53.
IMPORTANT: Youmustprogramthemoduleinorderto
useitwiththeControlPanel.
Figure 11 Control Panel with 2GIG Go!Control POTS Module
GSM (Cellular) Radio Module
IfinstallingtheGSM(Cellular)RadioModule,seebelow:
Figure 12 In-Wall Antenna Installation
NOTE: Theroutingoftheantennawireiscritical.Youmust
routethewireexactlyasdirectedorcellradio
interferencewilloccur.
1 Whenusingexternalantennas,plugtheantenna
connectorintotheGSM(Cellular)RadioModule.The
antennadropsint othewallormountsintheatticwith
A GSM(Cellular)RadioModuleConnector
B Endofantennahangsdowninsidethewall