Nortek 2GIG GC2 - Toolbox and Installer Toolbox; Accessing Toolbox Features

26Copyright©2016NortekSecurity&Control
Toolbox and Installer Toolbox
TheControlPanelincludestwo(2)differenttoolboxesfor
programmingthesystem:
• Tool box.Individualswithausercodecanaccess
basicprogrammingfunctionsintheenduser
Toolbox.
• InstallerToolb ox.Individualswiththeinstallercode
canaccessboththebasicprogrammingfunctionsof
theuserToolboxandthemoreadvanced
programmingfunctionsoftheInstallerToolbox.
Toolbox Screens
TheToolboxprovidesindividualswhopossessausercode
withtheabilitytoaccessbasicprogrammingfunctions.
Accessing the Toolbox
ToaccessthebasicToolboxscreens:
1 AttheHomescr een,tapSecurity,thenMenu,andthen
Tool box.
2 AttheEnterYourCodetoAccesstheToolboxscreen,
enterausercode.Thedefaultusercodeis1111.
Figure 27 Enter Your Code Screen
3 WhentheToolbox(1of3)screenappears,taptheleft
andrightarrowstoscrollbetweenthedifferent
screens.
Eachscreenprovidesdifferentbuttonsforaccessing
differentfeatures.
Figure 28 Toolbox (1 of 3)
Figure 29 Toolbox (2 of 3)
Figure 30 Toolbox (3 of 3)
Installer Toolbox Screens
TheInstallerToolboxscreenprovidesindividualswho
possesstheinstallercodewiththeabilitytoaccessavariety
ofsystemconfigurationandtestingbuttons.
NOTE: TheInstallerToolboxisonlyaccessiblewhenthe
systemisdisarmed.TheinstallercodedoesNOTdisarm
thesystem.Youmustknowtheusercodetodisarmthe
system.
Accessing the Installer Toolbox
Therearetwo(2)waystoaccesstheInstallerToolboxon
theControlPanel:
•AttheHomescreen,tapthesystemlogointhelower‐
rightcornerandthentaptheInstallerToolboxbutton.
Finally,entertheinstallercode.
OR
•AttheHomescreen,tapSecurity>Menu>Toolbox.
ThentaptheInstallerToolboxbuttonandenterthe
installercode.
Thedefaultinstallercodeis1561.Tolearnhowto
changethiscode,see
Q43:InstallerCode(4Digits).
Accessing the System Configuration for
System and Sensor Programming
Toaccessthesystemconfigurationscreensfor
programmingsensorsintothesystem:
1 TapDisarmandenteravalidusercode.Thedefault
usercodeis1111.
2 AccesstheInstallerToolbox.SeeAccessingtheInstaller
Tool boxabove.
3 AttheInstallerToolboxscreen,taptheSystem
Configurationbutton.