Nortek 2GIG GC2 - Final Installation Setup; Exiting Programming and Customization

Copyright © 2016 Nortek Security & Control 65
Final Installation Setup
Exiting Programming (System
Configuration)
AfterprogrammingtheControlPanel,allthechangesneed
tobesavedinmemory.Aftersaving,theprogrammed
settingswillremaininmemory,evenafteratotalpower
loss.
1 Aftersettingalltherequiredprogrammingvaluesfor
thesensorsandtheControlPanel,tapEnd.
2 ReviewtheSummaryofSystemConfigurationscreen.
Usethe↓and↑arrowstoscrollthroughthelisng.
Verifythateachoptionissetcorrectly.
Figure 56 Summary of System Configuration Screen
3 To savetheprogrammingchanges,besuretheSave
Changesoptionischecked.Toexitwithoutsaving
programmingchangesun‐checktheSaveChanges
option(forverification,anadditionalconfirmation
screenappears).TapExit.
4 TheControlPaneltakesafewsecondstorestartand
displaytheHomescreen.
Customizing the Installation
AfterprogrammingtheControlPanel,gototheUser
Toolboxandcustomizethesystemtosuittheinstallation.To
accesstheUserToolbox,dothefollowing:
1 FromtheHomescreen,tapSecurity.
2 FromtheSecurityscreen,tap,Menu.
3 FromtheMenuscreen,tapToolbox.
4 Enterthemasterusercode(thedefaultmasteruser
codeis1111).
5 TapUserManagement.
6 To add,change,ordeleteausercode,tapaUser#
button.Thesystemaskstoconfirmthecodeentered.
BesuretosetaDuressCodeasUser#8.
Figure 57 User Management Screen
NOTE: Usercodes0000,0001,andtheInstallerCodeare
notpermitted.
7 SetupeachusercodewiththeUserAccessOption
screen.EachUserCodecanbesettobecurrentlyvalid
ornot,ortohaveconditionalvalidity.RefertotheUser
GuidefordetailsonsettingUserCodeAccess
Schedules.Whendone,tapBack.
8 AttheToolbox(1of3)screen,tapBrightness/Volume.
Thensetthebrightnesslevelforthedisplayscreenand
thevolumeforthechime&voice.Whendone,tapOK.
Figure 58 Brightness/Volume Screen
9 AttheToolbox(1of3)screen,tap→togotothe
Tool box(2of3)screen.
10 TapBacklightTimeout.Thentapthebuttonthat
correspondstothenumberofsecondsorminutesthe
backlightturnsOFFafteritisidle.Whendone,tapOK.
Figure 59 Back Light Timeout Screen
NOTE: IftheGSM(Cellular)RadioModuleisproperly
installedandregistered,thesystemautomaticallysets
thedateandtimeforyou.Usethefollowingstepsonly
ifyouwanttochangethedateandtime.