Nortek 2GIG GC2 - Radio Status Test; Cell Phone Test

Go!ControlWirelessSecuritySystem|InstallationandProgrammingGuide
68Copyright©2016NortekSecurity&Control
2 WhentheSystemTest:Sensorsscreenappears,you
cantapthe↓and↑arrowstoscrollthroughthe
sensorlist.
Figure 63 System Test: Sensors Screen
3 Walktothefirstsensorinthelist,andthenactivate
thatsensortotestit.
Whenthepanelreceivesthesignal,itemits(3)beeps
andthenGREENorREDbarsshowthesignalstrength.
Thegreaterthenumberofbars,thehigherthe
strength.Ifthesignalissufficient,acheckmark
appears.Ifinsufficient,an“x”appears.
Figure 64 System Test: Sensors Screen/Signal Strength
4 Repeatthetestforeachsensorinthelist.Ifyouare
testingasensorwithmultipleloops,(forexample,a
Smoke/Heat/Freezealarm),wait15secondsbetween
eachloop’stest.
NOTE: Ifasensorisnotdetected,nosignalwillregister.Tap
OK.ThenattheSensorsTestFailedscreen,tapOK.
5 AttheSystemTest:Consolescreen,tapeachbuttonto
testthepanel’sLEDbuttonsandaudio.
Figure 65 System Test: Console
6 Whentheconsoletestsarecomplete,tapOK.When
thetestissuccessfullycompleted,tapOKtoexitWalk
Testmode.Thesystemsendsa“StopTest ”reporttothe
CentralStation.
Radio Status Test
IftheGSM(Cellular)RadioModuleisinstalledinthe
ControlPanel,usetheRadioStatusscreentoviewsignal
strength,serialnumber,registrationstatus,andother
informationforthecellularconnection.Theisahelpfultool
tousewhentroubleshootingtheinstallation.
Cell Phone Test
Toperformacellphonetest:
1 AttheInstallerToolboxscreen,tapRadioStatus.
Figure 66 Installer Toolbox: Radio Status
2 AttheRadioStatusscreen,tapCellPhoneTest.
Figure 67 Radio Status Screen
TheCellPhoneTestscreenappearstorevealstatus
messagesandte stresults
Figure 68 Cell Phone Test Screen
3 Whentheresultsappear,tapthe↓and↑arrowsto
reviewthemessages:
•REDtextindicatestheteste dsignalstrengthiszero,
toolow,orthattheGSM(Cellular)RadioModuleis
unregistered.
•ORANGEtextindicatestheconnectionisidleand
theGSM(Cellular)RadioModuleisregistered.
• GREENtextindicatesgoodsignalstrengthandthat
theGSM(Cellular)RadioModuleisregistered.