Nortek 2GIG GC2 - System Reset Options; Soft and Hard Reset Procedures

Installer Testing
Copyright © 2016 Nortek Security & Control 69
4 Whentheresultsaresuccessful,tapOKtoreturntothe
Tool box(3of3)screen.
Telephone Test
Usethistesttoverifytheland‐lineconnectionfromthe
panel’ sbuilt‐indigitalcommunicatorandCentralStation.
1 AttheToolbox(3of3)screen,taptheTelephoneTest
button.
Figure 69 Toolbox (3 of 3) Screen
2 AttheEnterMasterCodetoAccessTelephoneTest
screen,enterthemastercode.
TheTe
lephoneTestscreenappearstorevealstatus
messagesandte stre sults.
3 Tapthe↓and↑arrowstoreviewtheresults.
4 Whentheresultsaresuccessful,tapOKtoreturntothe
Tool box(3of3)screen.
Restore Default System Configuration
YoucanrestoretheControlPanelsettingsbacktoitsfactory
defaults.Therearetwo(2)typesofresetoptions:Softand
hard.
Soft Reset
Asoft‐resetletsyouselectwhichsettingstorestorebackto
thefactorydefaults.
Toperformasoft‐reset:
1 AttheInstallerToolboxscreen,taptheRestoreDefault
button.
TheRes
toreDefaultSystemConfigurationscreen
appears.
Figure 70 Restore Default System Configuration Screen
2 AttheRestoreDefaultSystemConfigurationscreen,
selectoneorbothcheckboxes:
• Zones.Placeacheckmarkinthisboxtoreplace
dataforALLsensorswiththefactorydefaultvalues.
AND/OR
• Console.Pl
aceacheckmarkinthisboxtoreplaceall
oftheprogramminganswerswiththefactory
defaults.Thiserasestheusercodes,resetsthe
backlighttimeouttofive(5)minutes,andresetsthe
Brightness/Volumesettings.
IMPORTANT: Thisactiondoe
snotrestorethefactory
defaultsettingsforZ‐WavequestionsQ79‐Q83.
Hard Reset
Ahard‐resetrestoresalloftheprogrammingsettingsback
tothefactorydefaults.
NOTE: Be
foreperformingahardreset,Q44:LockInstaller
Programming
mustbesettooption(1)or(2)andQ45:
LockDefaultProgrammingmustbesetto(0).See"Q44:
LockIns
tallerProgramming(0‐2)"onpage57.
Toperf
ormahardreset:
1 RemovetheControlPanelcoverandcompletely
disconnectallpowertotheControlPanel.
2 OntheinsidebackoftheControlPanel,pluginthe
backupbattery.
3 TapandholddowntheEmergency andHome
buttons.
4 ContinuetoholddowntheEmergency andHome
buttonsan
dthenconnectDCPowertotheControl
Panel.
5 ReleasethebuttonsonlyafterboththeEmergency 
andHo
mebuttonsarelitandtheControlPanelscreen
appears.