Nortek 2GIG GC2 - Q2: Wired Sensor Programming Outline; Summary of Wired Sensor # Screen; Wired Sensor Programming Questions

Installer Programming
Copyright © 2016 Nortek Security & Control 45
• Q:WiredSensor#VoiceDescriptor.Specifythe
nameassignedtothesensorthatisannounced
ifthisfeatureisprogrammed.
• Q:Wi
redSensor#Reports.Specifywhetheror
nottosenddigitalcommunicatorreportsfor
thesensor.
• Q:Wi
redSensor#Chime.Selectvoice
announcementandchimeoptionsforthe
sensor.
Q2: Wired Sensor Programming Outline
Figure 52 Wired Sensor Programming Outline
Scrollbetweenoponsusingthe←and→arrows.Moveto
thepreviousornextpromptbytappingthe↑and↓
arrows.
1 ToprogramanothersensortapNext.
2 Toexitprogramming,tapSkipthenEndandExit.Upon
exit,thepaneltakesseveralsecondstorestart.
Summary of Wired Sensor # Screen
Afterset tingalltheoptionsforasensor,thewiredsensor
summaryscreenisdisplayed.Thescreencanalsobe
displayedforprogrammedsensorsduringwiredsensor
programeditingbytappingtheSumbutton.
•Whilepr
ogrammingeachwiredsensorremember
thatthe←and→arrowbuonsstepthrougheach
ofthewiredsensornumbers.
•Toret
urntoprogramming,tapEditCurrentorEdit
Next.
•TapSkiptogotoquestionnumberQ3(RFKeyFob
Progr amming).See"Wireless(R
F)KeyFob
Programming"onpa
ge47.
Figure 53 Summary of Wired Sensor # Screen
NOTE: Forthedetailedstepsofprogrammingawired
sensor,see"WiredSe
nsorProgrammingQuestions"on
page45.
Wired Sensor Programming Questions
Q2: Select Wired Sensor # (1-2)
Twohardwiredloopscanbeusedassensorswitheach
ControlPanel.Theoptionsforeachwiredsensorare
programmedwithsub‐optionquestions.
•Beginbyen
teringthewiredsensornumberor
selectitusingthe←or→arrows.
•Afterse
lectingthewiredsensornumber,program
thewiredsensordetailsbyusingthe↑and↓
arrowstoselecteachofthesub‐options.
NOTE: Tosk
ipwiredsensorprogramming,tapSkiptojump
fromquestionQ2toquestionQ3.See"Wireless(R
F)Key
FobProgramming"onpa
ge47.
Q: Select Wired Sensor# Type
DEFAULT:(00)Unused
Eachwiredsensorneedstobeassignedtoasensortype.
Selectthesensortypethatmatchesthewiredsensor’s
funconusingthe←or→arrowsorenterthesensortype
numberdirectlyonthekeypad.
Inthetablebelow,a“YES”indicatesthesensortypecanbe
usedforthewi
redsensor.An“NO”indicatesthesensor
typeisnotused.
SensorTypes(Zones) RF
Sensors
Wired
Sensors
(00)Unused Yes Yes
(01)Exit/Entry1 Yes Yes
(02)Exit/Entry2 Yes Yes
(03)Perimeter Yes Yes