Page 138 951/952 Operator’s Manual Rev. B
Chapter 10 - Using Other Special Functions
sequence stops when the alarms either automatically clear or
you manually clear them.
NOTE:
If you want all alarms to honk, you must first set the
ALARM AUDIO
field to
ON
.
To set all alarms to honk:
1. Press the to highlight the HONK OUTPUT
field, then press the menu key.
2. Press the to select ALL ALARMS.
3. Press the key.
Table 7 below illustrates exactly how to set the anchor-watch
alarm and all other alarms to the desired audio.
Table 7: Beep and honk settings for all alarms
Sound Type Setting(s) Description
Beep All alarms Set alarm audio field to ON The unit’s standard alarm beep.
Beep Anchor watch Set alarm audio field to ON
Set anchor alarm field to ON
The unit’s standard alarm beep.
Honk All alarms Set alarm audio field to ON
Set honk output field to ALL
ALARMS
Exclamation point flashes on the
ALARMS screen (952) or
ALARMS &
BACKLIGHT SCREEN (951); the unit
simultaneously emits an output sound
for half a second, followed by silence for
half a second.
Honk Anchor watch Set anchor alarm field to ON
Set honk output field to
ANCHOR ALM
For 10 seconds, the exclamation point
flashes on the ALARMS screen (952) or
ALARMS & BACKLIGHT
screen
(951), and the alarm beeps (if alarm
audio is on), then the honk sequence
starts.
To Next Page
Loading...
