Page 88 951/952 Operator’s Manual Rev. B
Chapter 6 - Creating Waypoints
the WAYPTS CHART screen or from any of the waypoint list
screens.
Updating from the
chart screen
1. Select the waypoint on the CHART screen by positioning
the cursor over it so that the waypoint’s name and coordi-
nates are displayed in the INFO BAR at the bottom.
2. Press the key, the menu
key, then the menu key.
3. Press the menu key.
4. Press the key.
The unit updates the waypoint’s coordinates to your exact
position at the instant you pressed the menu
key.
Updating from a
list screen
1. Press the key, then the
menu key.
2. Press the menu key to show the LOCAL
screen (in order of distance from your position). The way-
point you intend to update should be at or near the top of
this list.
3. If necessary, press the to point to the
desired waypoint.
4. Press the menu key.
5. Press the menu key.
To Next Page
Loading...
