NTI ENTERPRISE ENVIRONMENT MONITORING SYSTEM
67
Account Settings Description
Username Enter the desired username for this user
Admin Place a checkmark here if this user should have administrative privileges
Enabled Place a checkmark here to enable this user to access the ENVIROMUX
Password Enter a password that a user must use to login to the system
A password must be assigned for the user’s login to be valid
Passwords must be at least 1 keyboard character.
Confirm Re-enter a password that a user must use to login to the system
Title Enter information as applicable
Department Enter information as applicable
Company Enter information as applicable
Group Settings
Group 1-8 Place a checkmark if the user should receive messages from sensors, accessories, or IP
devices in Group 1, 2, 3… thru 8 (see also pages 36 and 50 for group assignments)
Contact Settings
Email alerts Place a checkmark if the user should receive messages via email
Brief email Place a checkmark if email messages should be brief (contain only critical information)
Email address Enter a valid email address if this user should receive email alert messages (1 address only,
maximum 63 characters)
Syslog alerts Place a checkmark if the user should receive alerts via syslog messages
SNMP traps Place a checkmark if the user should receive alerts via SNMP traps
Syslog/SNMP IP address Enter a valid syslog/SNMP IP address for the user to receive syslog/SNMP messages
SMS Alerts Place a checkmark if the user should receive alerts via SMS messages
SMS Number Enter a phone number for the GSM modem to call to alert the user via SMS message
Schedule Settings
Schedule Type
Always active- user will receive messages at all hours of each day
Active during defined times- user will only receive alert messages during times as
outlined below
Start Day First day of the week the user should begin receiving messages
End Day Last day of the week the user should receive messages
Start Hour First hour of the day the user should begin receiving messages
End Hour Last hour of the day the user should receive messages
SNMP Settings
Authentication Protocol Choose between MD5 or SHA to require authentication, or none to disable it
Authentication Passphrase Assign the passphrase to be used to enable the receipt of SNMP v3 messages
Privacy Protocol
Choose between DES or AES to encrypt SNMP readings or traps or “None” to disable
encryption. If encryption is enabled, then the Authentication Protocol must also be set at “MD5”
or “SHA”.
Privacy Passphrase
Assign the passphrase to be used to open and read readings or alert messages received via
SNMP v3
Traps Type Choose between SNMPv1, SNMPv2C, or SNMPv3
After changing any settings in the user profile, press “Apply”.
If a user is set with only "User" rights instead of "Administrator" rights, the user will only be able to see current sensor readings
and to change their password if so desired. No other ENVIROMUX access it possible.
Note: If the root user’s password is changed and forgotten, contact Network Technologies Inc at (800) 742-8324 (800-
RGB-TECH) or (330) 562-7070 for assistance.
Note: Each user can have only one email address (maximum 63 characters) associated with that user. If an additional
email address is needed, an additional user must be added with the desired email address. As long as both users are
configured to get messages from the same sensor groups, both email addresses will get the same alert messages. For
more on users and sensor groups, see page 38.
To Next Page
Loading...
Need help?
General
