In Camera Setup, press Action to call up Detection Action Setup as shown.
It allows the administrator to define how the system responds to the detected motion for
the camera.
Following is a brief description for each item and its specific operations:
Camera – Press the Numeric to select the camera.
Duration – response duration to define at most how long (in seconds) the Alarm Out
relay and the Buzzer will keep being triggered after motion is detected for this
camera. However, the Alarm Out relay and the Buzzer will be reset immediately once
the camera returns to normal. The value (3 seconds - 60 minutes, discrete, ‘-‘ for
‘Forever’).
Camera to go – the camera to go to the preset position in next field after motion is
detected for this camera. “Camera to go” camera must be a PTZ camera.
Goto Preset – to define the preset position to go to for the “Camera to go” Camera in
last field if motion is detected for this camera. For more details about preset locations,
please refer to Section 5.6. PTZ Control.
Pre-record – to define how long before motion is detected this camera shall be
intensively recorded at Pre-record IPS. Please note that the actual pre-record time
may be shorter than the value set if the total size of the pre-record pictures exceeds
the pre-record buffer size of the system.
Post-record – to define how long after motion is detected this camera shall be
intensively recorded at Event Record IPS.
Alarm Out – to define which Alarm Output will be triggered when this event is
triggered. Press to select Alarm Output Source.
Buzzer – to activate the internal Buzzer or not when motion of this camera is
detected.
Log – to log to event logs or not.
Screen Message – to display the event message on the screen or not.
E-mail – to send the event e-mail to remote station or not. The e-mail will be sent
to the predefined receivers when the event is triggered.
FTP – to send the recorded event video/audio files to FTP server or not.
To Next Page
Loading...