7 DC electrical specifications
The following table describes the DC electrical specifications.
Table 5. DC electrical specifications
Symbol Parameter Conditions
Value
Unit
Min Typ Max
I
DD_LV
Maximum operating
current on the V
DD_LV
supply
1
MPC5746R/
MPC5745R
— — 700 mA
MPC5743R/
MPC5742R
— — 610
I
DD_LV_PE
Operating current on the
V
DD_LV
supply for flash
program/erase
—
— — 40 mA
I
DD_HV_PMC
Operating current on the
V
DD_HV_PMC
supply
2
Flash read — — 40 mA
Flash P/E — — 70
PMC only — — 35
Operating current on the
V
DD_HV_PMC
supply
(internal core reg
bypassed)
Flash read — — 10 mA
Flash P/E — — 40
I
VRCCTRL
Core regulator DC current
output on VRC_CTRL pin
—
— — 25 mA
I
DDSTBY_ON
32 KB RAM Standby
Leakage Current
(standby regulator on,
RAM not operational)
3, 4, 5
V
DDSTBY @
1.3 V to
5.9 V, T
J
= 150 °C
— — 575 µA
V
DDSTBY @
1.3 V to
5.9 V, T
A
= 40 °C
— — 55
V
DDSTBY @
1.3 V to
5.9 V, T
A
= 85 °C
— — 65
I
DDSTBY_REG
32 KB RAM Standby
Regulator Current
6
V
DDSTBY @
1.2 V to
5.9 V, Tj = 150 °C
— — 50 µA
I
DD_LV_BD
BD Debug/Emulation low
voltage supply operating
current
7
T
J
= 150 °C
V
DD_LV_BD
= 1.32
V
—
— 250 mA
I
DD_HV_IO_BD
Debug/Emulation high
voltage supply operating
current (Aurora + JTAG/
LFAST)
T
J
= 150 °C — — 130 mA
I
BG
Bandgap reference
current consumption
— — 600 µA
I
DD_BD_STBY
BD Debug/Emulation low
voltage supply standby
current
T
J
= 150 °C
V
DD_LV_BD
= 1.32
V
— — 120 mA
I
VDDA
VDDA supply current — 16 25 mA
1. Value is derived from a typical application at 200MHz, Core 0 Data and Instruction Cache On, Core 1 in Lockstep mode,
typical usage for SARADC, SDADC, DMA, eTPU, eMIOS, CAN, MSC, SPI, SENT, PIT, and Flash reads.
DC electrical specifications
SPC5746R Microcontroller Data Sheet, Rev. 6, 06/2017
NXP Semiconductors 11