Document revision history
MPC5777M Microcontroller Data Sheet, Rev. 6
NXP Semiconductors 153
3 3/2014
Electrical characteristics—DC electrical specification
Table 10 (DC electrical specifications):
• Changed footnote 11, to “The standby RAM regulator current is present on the
VDDSTBY pin whenever a voltage is applied to the pin. This also applies to normal
operation where the RAM is powered by the VDD_LV supply. Connecting the
VDDSTBY pin to ground when not using the standby RAM feature will remove the
leakage current on the VDDSTBY pin.”
•Moved V
REF_BG_T
, V
REF_BG_TC
and
V
REF_BG_LR
specifications from ADC pin
specification table to DC electrical specifications table.
• Removed I
FERS
row.
•V
STBY_BO
and V
DD_LV_STBY_SW
removed from the Device operating conditions table
and added to the DC electrical specifications table.
• Changed I
DD_LV
maximum value to 850 mA (was 910).
Electrical characteristics—DC electrical specification (con’t)
Table 10 (DC electrical specifications):
• Changed I
DD_LV
maximum value to 850 mA (was 910).\
•I
DD_LV_BD,
changed “250” to “290” mA.
•I
DD_BD_STBY
, 150
o
C condition, changed “120” to “230” mA.
•I
DD_MAIN_CORE_AC
: Added footnote "There is an additional 25mA when FERS=1 to
enable the fast erase time of the flash memory."
•In VDD_HV_PMC availability footnote, changed “QFP” to “416 BGA” and “BGA” to “512
BGA.”
• Revised footnote “If Aurora and JTAGM/LFAST not used, V
DD_LV_BD
current is reduced
by ~20mA.”
• Removed silicon characterization footnote.
Table 12 (I/O input DC electrical characteristics):
•V
DRFTAUT
specification, conditions column, added “4.5 V < V
DD_HV_IO
< 5.5 V”.
•V
DRFTCMOS
specification, added 3.0 V < V
DD_HV_IO
< 3.6 V and 4.5 V < V
DD_HV_IO
<
5.5 V conditions.
•I
LKG
specification, entire row revised.
• Changed footnote 6 “n the range 4.5 V < VD
D_HV_IO
< 5.9 V.” to “in the range 4.5 V <
V
DD_HV_IO
< 5.5 V.
•V
HYSAUT
conditions column: replaced dash with 4.5 V < V
DD_HV_IO
< 5.5 V.
•C
IN
row, changed GPIO input pins conditions Max value from “10” to “7” pF and EBI
input pins Max value from “8” to “7” pF.
•I
LKG_EBI
removed “Vin = 10%/90%” from parameter column.
Figure 18 (I/O output DC electrical characteristics definition): Replaced figure.
Table 76. Revision history (continued)
Revision Date Description of changes
To Next Page
Loading...
