MPC5777M Microcontroller Data Sheet, Rev. 6
Document revision history
NXP Semiconductors154
3 3/2014
Electrical characteristics—I/O pad specification
Table 13 (I/O pull-up/pull-down DC electrical characteristics):
•I
WPU
, I
WPD
: substantially revised these specifications.
Table 14,Table 15,Table 16,Table 17:
• Added footnote to “C” classification header: "Once device characterization is
correlated to production I/O testing, the test classification of output resistance
parameters may be subject to change in future revisions of this document."
•R
OH_W
, R
OL_W,
R
OH_M,
R
OL_M,
R
OH_S,
R
OL_S,
R
OH_V,
R
OL_V
: Changed classification to
C (was P).
• Removed all VSIO conditions (VSIO[VSIO_xx] = 1 and VSIO[VSIO_xx] = 0) from
conditions column and added footnote: “All V
DD_HV_IO
conditions for 4.5 V to 5.9 V are
valid for VSIO[VSIO_xx] = 1, and all specifications for 3.0 V to 3.6 V are valid for
VSIO[VSIO_xx] = 0.”
• Removed T
PHL/PLH
specification from WEAK, MEDIUM, and STRONG configuration
output buffer electrical characteristics.
• Removed characterization and validation footnotes (total 2) for each table.
Table 14, Table 15, Table 16:
•R
OH_
, R
OL_
, t
TR_
: Changed 5.9 V conditions to 5.5 V.
Table 15,Table 16,Table 17:
• Added t
TPD10-90
specification.
Table 16, Table 17:
• In footnotes, changed 5.9 V to 5.5 V.
Table 18 (EBI pad output electrical specification):
• Replaced this table “EBI output driver electrical characteristics” with new table “EBI pad
electrical specification”.
Table 19 (I/O consumption)
•I
RMS_EBI
: In Conditions column, changed 66MHz references to 66.7MHz. Removed
C
DRV
= 6 pF condition row.
•I
DYN_EBI
: revised specification.
Electrical characteristics—I/O pad current specification
Section 3.7, I/O pad current specification: Changed the first note: from “In order to ensure
correct functionality for SENT, the sum of all pad usage ratio within the SENT segment
should remain below 50%.” to “In order to maintain the required input thresholds for the
SENT interface, the sum of all I/O pad output percent IR drop as defined in the I/O Signal
Description table, must be below 50 %. See the I/O Signal Description attachment.”
Electrical characteristics—Reset pad (PORST, ESR0) electrical characteristics
Table 20 (Reset electrical characteristics):
•|I
WPU| parameter, changed Min value from “25” to “23” and Max value from “100” to “82”
uA.
•|I
WPD| parameter, changed Min value from “25” to “40” and Max value from “100” to
“130” uA.
Table 76. Revision history (continued)
Revision Date Description of changes
To Next Page
Loading...
