12 Patient Data Management
Instruction Manual Mesotest II (G/62800/0715/en) 67 / 86
12.5.7 "Misc" tab
The Patient Data Management user interface is available in two different
versions: V2.x and V6.x. In principle, implementing both versions on the
same network should be avoided. In any case, if it is unavoidable due to
the higher technical requirements of the new version V6.x, then the
corresponding settings must be set on this tab.
Enable the checkbox on this tab (1) on exactly one computer that
has version V6.x installed.
Make sure that this checkbox is not enabled on any other computer
which has version V6.x of the Patient Data Management user
interface installed.
Enable Checkbox (2) so that data from the database will be read in
again after the next start.
This ensures that the database is automatically updated when a patient
is created on a computer with the older Patient Data Management V2.x.
The "IPad Report" field is currently disabled.
1 Checkbox to manage the database 2 Check box to import the database
Fig. 12-13: "Misc" tab
To Next Page
Loading...
