7 Initial Operation
Instruction Manual Mesotest II (G/62800/0715/en) 19 / 86
7.4 Software Installation
Before first use, you must install the Mesotest II software on your laptop
or PC. Proceed as described in the Software Installation.
For installation on a computer/laptop, we recommend:
2 GB RAM, Windows® 8, free USB port
As of April 2014, Microsoft® no longer provides support for the operating
system Windows™ XP. This means that Microsoft® no longer provides any
operating and security updates for Windows™ XP.
If you continue to use this operating system after support has ceased,
your computer and your data are susceptible to greater security risks. We
recommend that you:
Disconnect your computer from the internet and use it as a stand-
alone solution, or
Upgrade to the latest Windows™ version
You can only conduct the examination with the computer when you use
the supplied floating license key and the current version of the device
software has been installed on the computer.
Plug the floating license key into one of the computer’s USB ports.
The software then installs itself.
7.5 Switching the Device On and Off
Switch the Mesotest II on or off at the On/Off switch at the unit
(fig. 7-2, page 18, item 3).
If the Mesotest II is connected with a control pad, the unit starts
automatically.
If the Mesotest II is connected with a netbook, laptop or PC, you
must start the software, sec. 10.3.1, page 37.
To Next Page
Loading...
