13 Cleaning, Disinfection and Maintenance
72 / 86 Instruction Manual Mesotest II (G/62800/0715/en)
Make sure that the small air ducts on the back are not folded over.
First insert continuous yoke of the yoke spring into the top guide
groove.
Make sure that the yoke sits fully in the groove.
Then take hold of the two bent ends of the yoke spring, one after the
other, and hook them back into place in the bottom groove.
13.4.2 Replacing the Fuse
The Mesotest II has two fuses. These are located in a small fuse box
integrated in the mains power plug.
You can replace a blown fuse.
Note:
Function loss due to incorrect fuse
Use only the fuse type that is specified on the rating plate, sec. 2,
page 2.
Turn the Mesotest II off, sec. 7.5, page 19.
Unplug the power cord.
Open the drawer. To do this press on the lug on the top of the drawer.
Pull out the drawer.
Replace the blown fuse.
You can recognise a blown fuse by the burnt filament.
Push the drawer back in until the lug snaps back into place.
Connect the Mesotest II to the mains.
You can now turn on the Mesotest II and start doing exams.
Fig. 13-4: Inserting the yoke springs
Fig. 13-5: Pull out the fuse holder
To Next Page
Loading...
