13 Cleaning, Disinfection and Maintenance
68 / 86 Instruction Manual Mesotest II (G/62800/0715/en)
12.5.8 "Hecht" and "DICOM" tabs
"Hecht" and "DICOM" tabs are currently disabled.
13 Cleaning, Disinfection and Maintenance
This chapter describes how to clean and disinfect the Mesotest II and how
to change the viewer enclosure, the fuses and the panel illumination
lamp.
To ensure satisfactory and reliable operation, we recommend that you
have the Mesotest II checked every two years by our service department
or an authorized dealer. If an error occurs which you are unable to correct,
label the Mesotest II as “out of order” and contact our service department
or an authorized dealer.
Attention
Risk of electric shock if the Mesotest II is not completely disconnected
from the mains for these jobs.
Turn the Mesotest II off, sec. 7.5, page 19.
Unplug the power cord before cleaning, disinfection and
maintenance, sec. 13.1, page 68.
Always heed the product descriptions and directions for use of
products you use to care for, clean, and disinfect the unit and/or its
accessories.
Do not clean the Mesotest II with aggressive, chlorinated, abrasive
or sharp cleaning agents.
13.1 Unplug the Equipment
Turn off the unit with the On/Off (3) switch.
1 Mains connection 3 On/Off switch
2 Plug for the control pad/computer/laptop
Fig. 13-1: Plug connections of the Mesotest II
To Next Page
Loading...
