10 Conducting the Examination with a Computer/Laptop
36 / 86 Instruction Manual Mesotest II (G/62800/0715/en)
In the dialogue box, select the location to which the data are to be
saved.
This interface (2) is used to establish a connection between the Mesotest
II and the computer.
Select the appropriate interface port.
Refer to the Operating Manual for your computer to find your
computer’s COM port numbers.
A notebook generally has only one port: COM1. A desktop computer
generally has two: COM1 and COM2.
Save your selection.
Switch to the Mesotest II programme
Press the [Back] button (fig. 10-7, page 32, item 8).
The settings will take effect immediately, except for the language
change.
10.3 Conduct the Examination
To conduct an examination:
Start the Patient Data Management, sec. 10.3.1, page 37
Select and start an examination, sec. 10.4, page 39
Test mesopic vision, sec. , page 41
Test mesopic vision with glare, if applicable, sec. , page 41
You can display and print out the results, sec. 10.5, page 45.
Prepare the patient for the examination, sec. 8, page 20.
To Next Page
Loading...
