2021-03-23 / Rev. 10 VV016042 117
Unscrew sensor (2 screws).
Release cable and mount the new
sensor in the reverse order of disas-
sembling.
CAUTION!
Incorrect pedal signals trans-
ferred to device
Faulty operation of device
► After this procedure, the pe-
dal needs recalibrating ac-
cording to 7.5.
When mounting the new sensor,
keep attention to the following
steps:
► Mount the sensor up to the
stop.
After mounting the new sensor,
fix the cable with the help of ca-
ble ties at the cable tie holders.
Ensure that the loop of the cable
enables sufficient moving space
for the sensor (see picture).
To Next Page