OERTLI OS 4 - Laser safety test procedures

Laser installation protocol
OS 4
VV016042, 2021-03-23 / Rev. 09
Customer
Address:
Company laser safety
officer:
Data of OS 4 device
Article no.:
Serial no. OS 4 device:
Software version OS 4
device:
App:
System:
Serial no. OS 4 pedal
Software version OS 4
pedal:
SW:
HW:
Serial no. endo laser:
Serial no. fiber coupling
unit:
Functional test
Observe Laser protective measures.
Measuring equip-
ment
Reference power meter
Type: _________
Serial no. _______________________
Reference power head
Type: _________
Serial no. _______________________
1.
Laser safety test
OK
Set key switch to „0“, LASER STOP key on, DRS plugged out, no fibre connected!
1.1
Select “Laser” function.
Message “Laser key switch off”
is displayed

Notice: _____________________________________________________________________________
1.2
Set key switch to “I”.
Message “Laser key switch off”
disappears, message “Laser
emergency switch activated” is
displayed

Notice: _____________________________________________________________________________
1.3
Undo LASER STOP key (OFF).
Message “Laser emergency
switch activated” disappears,
message “Laser: no fibre detec-
tion” is displayed

Notice: _____________________________________________________________________________