EnForcer™ SCR Service Manual I.B. 1561
3
AC LINE VOLTAGE LETTER CODES
The following table describes the code letters to be used in new charger part numbers to indicate the AC line voltage(s)
and AC line frequency at which the charger can be operated.
Code
Letters
Voltages(s) (volts
rms.)
Line Frequency
(Hz)
Comments
B 208/240/480 60 Applicable to all charger families; single or three phase chargers.
D 220/380/440 50 Applicable to all charger families; single or three phase chargers.
J 480/550/600 60 Applicable to all charger families; single or three phase chargers.
T* 208 60 Use only for special designs; single or three phase chargers.
W* 240 60 Use only for special designs; single or three phase chargers.
X* 240/480 60 Use only for special designs; single or three phase chargers.
Y* 480 60 Use only for special designs; single or three phase chargers.
E 400 50 Use only for special designs. Contact the plant for further information.
S Special Voltages Unspecified Use only for special designs. Contact the plant for further information.
*
Replacement part numbers for chargers with such letter codes shall be referred to the charger’s tables with code letter “B”
SPECIALTY CHARGER OPTIONS LIST
Suffix Description
C6 6’ of #10 AWG AC cord with 30 amp plug*
C10 10’ of #10 AWG AC cord with 30 amp plug*
C12 12’ of #10 AWG AC cord with 30 amp plug*
C8 8’ of #10 AWG AC cord with 30 amp plug*
CF 10’ of #8 AWG AC cord with 50 amp plug*
CF12 12’ of #8 AWG AC cord with 50 amp plug*
CR 6’ of #10 AWG AC cord with 30 amp Plug and 30 amp receptacle. *
D Charger with AC Disconnect Switch
G Outlet receptacle option, GFCI type
HD3 6’ of #10 amp AC cord with 30 amp plug*
HD4 6’ of #10 AWG AC cord with 30 amp plug and receptacle*
L10 10’ of DC cable
L13 13’ of DC cable
L15 15’ of DC cable
L18 18’ of DC cable
L20 20’ of DC cable
L25 25’ of DC cable
L30 30’ of DC cable
LM SCR charger with Load Management Control
NC No DC cable
O Special configuration of a standard EPROM **
P Parallel DC cables, standard size.
PP Charger Shipped on a Plastic Pallet
Q Voltage conversion Quick Tap
S Series DC cables
T Block out timer switch
Z Combination not listed
*When AC cord is installed at the factory only one input voltage is marked on the charger.
**Prior approval needed from Director of Engineering
To Next Page
Loading...