The Ultimate Ice Resurfacer 90
9 SELF- HELP AND TROUBLESHOOTING
9.1 Squeegee Replacement
If the squeegee needs to be replaced, it should be mounted on the inside of the conditioner
with hex head bolts (3/8” x 1-1/4”) and locknuts. Install the squeegee such that the ends t
tightly against the sides of the conditioner.
Snow that is pushed by the squeegee is trapped between the squeegee and the runners and
must not be able to escape to the outside, as it would form a ridge on the ice.
9.2 Towel Replacement
Inspect the towel and replace it if necessary. Attach the towel to the back of the towel holder
with hex head bolts (3/8” x 1”) and locknuts; make sure that the nuts are on the towel side of
the towel holder.
9.3 Blade Replacement
Refer to Chapter 6.3, “Installation and Removal of the Blade“.
To Next Page
Loading...