The Ultimate Ice Resurfacer 86
8.2.6 Annually or Before Storage
• Spray all metal surfaces of the conditioner with a thin coating of penetrating oil.
• Lubricate all lube points on the OLYMPIA to eliminate moisture.
• The horizontal and the vertical auger and all moving parts of the conditioner must be
coated with a thin coating of penetrating oil.
• Open the drains.
• Remove the lter basket from the wash water tank. Using a wet vac, vacuum out any debris
left in the tank.
• Remove the blade and properly store it.
• Oil the blade holder on the conditioner.
• Clean the ice resurfacer: Wash the OLYMPIA with luke- warm water and a mild soap. Make
sure that you rinse o the soap with cold water before it dries and causes streaking on the
surface of the OLYMPIA.
Never spray an open jet of water onto the ice resurfacer, as electrical components will be
damaged.
• Use a high- quality automotive wax to preserve the high- gloss nish of the OLYMPIA.
• Disconnect the battery charger and leave the batteries unplugged. If storing for more than
one month charge the batteries each month.
• Have a qualied technician tighten all connections in the control cabinet.
• Check the brake lines for leaks and wear.
• Grease the entire ice resurfacer.
• Change hydraulic oil lter.
To Next Page
Loading...
