The Ultimate Ice Resurfacer 14
1.10 Maintenance and Repair Regulations
In terms of this manual, maintenance work means all …
• maintenance jobs that have to be done periodically on the OLYMPIA.
• lubrication.
• cleaning.
• setup and retooling, changing of components / sub-assemblies.
• Adjustments/setting of the electrical equipment, mechanical parts and hydraulic systems.
• Never open the control cabinet and/or any electrical components while power is being
supplied to the machinery.
• The battery connector must be disconnected before doing any work on the ice resurfacer
(including changing the blades). The proper way to do this is to check to make sure the
snow dump tank is empty, then raise the tank to the fully open position, Remove the starter
key and properly dismount the resurfacer, and install the snow dump safety supports.
Disconnect the battery by separating the main power plug located directly infront of the
operators platform under the snow dump tank. Carry the key on your person. Put up a
notice on the ice resurfacer that says, DO NOT START.
• Before starting the work, cordon o the area in which the maintenance work is to be
done with a red/white safety chain and put up notices that read MAINTENANCE WORK IN
PROGRESS! UNAUTHORIZED ACCESS PROHIBITED. RISK OF INJURY.
To Next Page
Loading...
