The Ultimate Ice Resurfacer 78
7.3 Resurfacing Procedure
Once you have taken on sucient water, before driving onto the ice surface, turn on the tire
wash to rinse the tires of any debris. Now carefully drive onto the ice surface and carry out the
normal ice making procedure as follows:
• Lower the conditioner to the ice surface until the conditioner lift arms are against the
down pressure stops.
• Engage both the vertical and the horizontal augers by pushing the top of the elevator on
button.
• Turn on the ice making water with either the Speed Related Water button or the manually
operated water valve.
• Turn on the Wash Water button.
• Now engage the board brush.
• Drive slowly ahead keeping the board brush close to the boards. (This will clean the snow
on the kick plate and edges of the ice surface into the conditioner)
• Upon completion of a full circuit of the rink, retract the board brush and follow the pattern
shown below.
Use extreme caution with the board brush when passing open gates as the board brush could
swing into the opening, causing damage to both the boards and/ or the ice resurfacer.
To Next Page
Loading...
