The Ultimate Ice Resurfacer 48
Manual Ice Making Water Flow
The manual water function allows water to be applied to the ice at a constant rate, regardless
of the speed at which the ice resurfacer is travelling. It can also be used to supplement the
speed related water.
5.8 Controls for the Hydraulic System
Switching the Hydraulic Pump Motor On and O
There are two ways of switching on the hydraulic pump motor:
1. By pressing the accelerator pedal.
2. By pressing the appropriate function switch.
However, the ice resurfacer must be turned on at the ignition switch before the motor can be
started up.
The hydraulic pump motor is switched o either by turning o the ignition switch, or
automatically approx. 20 seconds after the accelerator pedal was last pressed, or as soon as
you let go of a function switch.
To Next Page
Loading...
