The Ultimate Ice Resurfacer 80
• Engage the parking brake and turn o the ice resurfacer.
• After stepping down from the ice resurfacer, be sure to remove cover plates and wash out
the conditioner.
In order to maintain the recommended ice thickness of 1-1/4” (36mm), it is important that
you cut the ice at a rate equal to the water you put down. Usually between ½ and ¾ a bin of
snow will equal the amount of water put down on an 8 to 10 minute resurfacing.
Proceed with extreme caution when driving up to the snow dumping area!
The snow dumping area should meet the following safety requirements:
• Red/white cordons at the left and right of the unloading area, with pictograms.
• Yellow/black threshold on the oor that is high enough to prevent the OLYMPIA from
falling into the dump.
• Guard at the front of the snow dump to prevent people from falling in.
7.3.1 Cleaning the Ice Resurfacer after an Ice Resurfacing Operation
The conditioner should be rinsed out after each use. Do not hose down the whole ice resurfacer
unnecessarily. The control cabinet, the hydraulic station, the battery panels and the driver’s
platform may only be cleaned with a damp cloth, never with a direct jet of water.
Keep the humidity in the storage area as low as possible!
To Next Page
Loading...