The Ultimate Ice Resurfacer 75
Operation and start-up must only take place from the driver’s seat!
Before driving onto the ice surface make sure pedestrian doors in the dasher boards are
closed.
Before leaving the driver’s seat, always turn o all functions!
7.2.1 Driving with the Board Brush
Normally the brush is used for the rst lap around the boards at the beginning of each ice
cleaning process.
This produces a clean, snow-free board area, right up to the edges. In connection with the
edger and the automatic water function, the use of the brush reliably prevents a build-up of
ice at the boards.
Drive with the brush in the same way as you would without the brush, but always travel in a
clockwise direction around the boards.
Never drive backwards while the brush is extended. The brush can yield to the boards in
the forward direction of travel, however, when driving in reverse, the brush could swing
into an opening and catch the boards, causing severe damage.
Retract thre board brush when approaching any ice level opening.
To Next Page
Loading...
