The Ultimate Ice Resurfacer 49
6 START UP OF THE OLYMPIA MILLENNIUM - E
6.1 Charge the Batteries
Before you can start work with the OLYMPIA, you must charge the battery. A battery charger is
supplied with the ice resurfacer for this purpose. This charger is designed to fully recharge a
battery that has been drained as close to 0% on the accumeter as possible.
1. Raise the snow dump tank fully and install the safety support bars.
2. The battery charger will indicate connect battery.
3. Push down the EMERGENCY SHUT OFF switch.
4. Carefully disconnect the power supply coupling located directly in front of the
operators platform above the rear wheel. Now plug the cable from charger into the
power supply coupling.
Battery gassing does occur in the nal stages of charging. Gassing emits dangerous hydrogen gas.
5. Pull up the EMERGENCY SHUT OFF switch.
The EMERGENCY SHUT OFF switch must be pulled up, otherwise charging will not take
place.