The Ultimate Ice Resurfacer 70
6.7 Safety Circle Check
1. Do a smell check
2. Turn on the lights
3. Be sure battery charge is complete. Check to make sure battery charger is turned o.
4. Remove the ignition key.
5. Depress Emergency Shut O switch.
6. Disconnect the battery cables and store.
7. Reconnect the internal power supply cables.
8. Make sure the front bumper wheel spins freely.
9. Check lug nuts and tire pressure and general condition of tire and studs on left front wheel.
10. At front of ice resurfacer check the body for damage
11. Look under ice resurfacer for any leaking uids, debris and make sure no one is working
under the ice resurfacer.
12. Check lug nuts and tire pressure and general condition of tire and studs on right front wheel.
13. Make sure both tank drains are closed.
14. Check lug nuts and tire pressure and general condition of tire and studs on right rear wheel.
15. Check the condition of the blade, in relationship to the runners. To avoid being cut by
the blade, always start at the rear of the conditioner and slide your hand towards the
front of the conditioner.
16. Check the runners for burrs that would leave scratches on the ice surface. Make sure
you go the full length of the runner. The runner should have no nicks or scratches on it
and the blade should be ush or slightly above the bottom of the runner.
17. Remove the conditioner cover on the right hand side and check that the horizontal
auger turns freely in both directions.
18. Make sure there is no up, down or side to side movement.
To Next Page
Loading...
