The Ultimate Ice Resurfacer 76
7.2.2 Water Application
Ice Making Water Procedure
1. Fill the tank with hot water through the ll pipe located on the driver`s side.
Note: A ½ full tank is more than sucient for a single resurfacing.
2. Water ow can be turned on and o two ways.
A: Gravity ow regulates the ow of water by opening or closing the water tap
mounted just in front of the blade adjustment hand wheel on the conditioner.
B: Turn on the speed related water on the bottom control panel. Ice making water will
then be pumped out according to how fast or slow you are driving.
After each resurfacing it is recommended to drain any excess water left in the tank. This
will reduce scale build up inside the ice making water tank.
Wash Water Procedure
The wash water system sprays water from both sides of the conditioner into the centre, in
front of the squeegee, thus creating slush. Excess water and slush are then vacuumed up,
taking with it any dirt and debris from the ice surface. In addition, any snow left behind by
the blade is turned into slush by the wash water and is pushed into any cracks in the ice by the
squeegee. The water is ltered and then returned to the wash water tank.
To Next Page
Loading...
