Olympia Millennium-E - Wash Water Filling Procedure

The Ultimate Ice Resurfacer 69
6.6.2 Wash Water Filling Procedure
Always ll the wash water tank with cold water only.
1. Insert the cold water hose into the lling inlet (Item 1) on the right side of the ice
resurfacer. Plug the solenoid valve plug into the socket on the Wash water ll station
(Item 2) on the exterior right hand side of the OLYMPIA’s control cabinet.
2. Turn the switch to the ON position, the water then begins to ow.
3. The lling procedure ends automatically when the tank is full.
4. Turn the switch to the OFF position, pull out the solenoid valve plug and remove the
hose from the lling inlet.
1.
2.