The Ultimate Ice Resurfacer 52
6.2 Installation of the Squeegee
Mount the squeegee on the inside of the conditioner with the bolts and nuts provided. .
If not already trimmed, carefully trim the ends of the squeegee so that it ts tightly against
the runners of the conditioner, as in the picture:
Squeegee Trimming
Snow that is pushed by the squeegee must
stay within the area between the squeegee
and the runners, and must not be pushed out
from there, as this would cause ridges to be
produced on the ice.
Squeege Clamp
Conditioner
Squeege
Fig. 6.1: Installation of the squeegee
Item 1 Conditioner
Item 2 Squeegee
Item 3 Squeegee clamp bar
To Next Page
Loading...
