EnForcer™ SCR Service Manual I.B. 1561
35
REPLACEMENT PARTS
CAUTION:
THERE ARE DANGEROUS VOLTAGES WITHIN THE BATTERY CHARGER CABINET.
ONLY QUALIFIED PERSONNEL SHOULD ATTEMPT TO ADJUST OR SERVICE THIS BATTERY
CHARGER.
PRINTED CIRCUIT BOARDS (CONTROL)
X1060-09-ES3-1 STANDARD MODELS
X1060-09-ES3-2 41-80 CELL
DESCRIPTION PART NUMBER
DOOR X054-99-3-17
TOP PANEL X052-99-3-12
BACK PANEL X057-99-3-16
SIDE PANEL, LEFT X057-99-0-5
SIDE PANEL, RIGHT (STANDARD OUTPUT HOLES) X057-99-0-6
SIDE PANEL, RIGHT (OUTPUT HOLES FOR 4/0 CABLE) X057-99-0-7
UPRIGHT X052-99-0-6
DOOR LATCH X044-1-32
RIVET FOR DOOR LATCH 164-8-6
TERMINAL BOARD, MAIN XFMR, LEFT 256-99-12
TERMINAL BOARD, MAIN XFMR, RIGHT 256-99-13
DC CABLE CLAMP (#2, 1/0, 2/0, & 3/0 CABLE) 356-5-15
DC CABLE CLAMP (4/0 CABLE) 356-5-16
FUSE REDUCER (<70A FUSE INTO 100A FUSE BLOCK) X014-17-6
FUSE REDUCER (<40A FUSE INTO 60A FUSE BLOCK) X014-17-5
GROUND LUG X012-7-24
PC BOARD FUSE X014-7-28
Base kits are required for base replacement. Each kit includes the base and cross-members for heat sink and
transformer mounting. Determine the appropriate kit for your charger from the following chart:
DESCRIPTION KIT PART NUMBER
11 INCH DISTANCE BETWEEN TRANSFORMER BRACKETS X225-99-3-11
15 INCH DISTANCE BETWEEN TRANSFORMER BRACKETS AND ALSO FOR (3) HEAT SINK
EXTRUSIONS
X225-99-3-15
To Next Page
Loading...
