The Ultimate Ice Resurfacer 58
Then turn the nuts to raise or lower the blade into the proper position, which is exactly level
with the bottom of the runner. Once the blade is at the proper level tighten the nuts on the
blade level adjuster nuts.
When the ends of the blade are ush with the runners, the majority of the blade will extend
1/16” (1,6mm) below the runners, which is an excessive cut.
To check the level of the blade, slide a large coin along the runners of the conditioner, from
back to front, until you feel it pass over the edge of the blade.
Safety Note: Be careful when doing the coin check. Make sure you are wearing gloves and
that you move the coin from back to front as the blades are extremely sharp.
To Next Page
Loading...
