The Ultimate Ice Resurfacer 82
Only after the OLYMPIA has been secured in the described manner may any isolating guards
be removed (if necessary).
Only duly authorized personnel are permitted to be in the vicinity of the machine when
maintenance and repair work is being performed.
If mechanically driven movements are necessary on the OLYMPIA in the course of
maintenance and repair work, these may only be executed on the instruction of the facility
supervisor, and at a safe, reduced speed.
Before starting the work, the employee responsible for doing the work must rst ensure
that this can be done without endangering people or facility equipment. Only after he has
done so may he switch the power back on.
Mechanically driven ice resurfacer movements can only be started in jog mode during
maintenance and repair work by holding the respective controls accordingly.
After completing the maintenance and repair jobs, the responsible employee must ensure
that the isolating guards are remounted and that there are no people in the danger zone.
After it has been ascertained that the ice resurfacer can be put back into operation without
endangering people or facility equipment, the responsible employee can restore the power
to the ice resurfacer by plugging the battery connector back in again. The people working
on the ice resurfacer must be informed in advance.
In an emergency, press the EMERGENCY SHUT OFF switch. Before reengaging the ice resurfacer,
make sure that this can be done without endangering people or facility equipment.
Employees must wear protective gloves when doing maintenance and repair work. The hazards
associated with the sharp components should be pointed out in regular training courses.
Any failure of, or damage to the safety devices or guards must be reported to the facility
supervisor without delay. He will then decide how to proceed.
To Next Page
Loading...
