DP2-SAL
19
Press the main switch
a
of the control box D2-CB to terminate it. Make
sure that the LED
b
is OFF completely (after approx. 10 seconds) and
disconnect the AC adapter.
Disconnecting the connector while LED
b
is ON will
cause a failure.
Disconnecting the AC adapter
a
b
· Do not use the AC adapter when the output plug is not inserted
completely.
· Never remove or insert the output plug of the AC adapter with
wet hands.
· If by any chance, the AC adapter or the cord is very hot, smells
burnt or smokes, unplug the power cord immediately and stop
using the AC adapter. Also contact Olympus immediately.
· Never use AC adapters which are not provided by Olympus.
The control box D2-CB or the camera head may be damaged
or an unexpected accident such as fire may occur. We are not
liable for any damage caused by using an AC adapter which is
not provided by Olympus.
· Never stretch out, bend or twist the cord of the AC adapter
forcibly. Also never extend it by adding another cord.
· If you find any scratch or disconnection on the cord of the AC
adapter or a bad connection is recognized on the output plug,
contact Olympus immediately.
· If not in use, unplug the power cord from the outlet .
· Do not connect the power cord to the wall outlet by putting
many plugs in one outlet or using a table tap extending to
many plugs. It may cause fire.
To Next Page
Loading...
