Olympus DP2-SAL - Selecting Exposure Mode; Exposure Compensation

DP2-SAL
25
2
Selecting exposure mode
If the setting items of Submenu on the [Controller] tab are not displayed,
Press [Submenu]
a
to open them.
Press the [AE] button
b
to select "Auto" or "Manual".
For procedures to set the exposure when "Manual" is selected, refer
to "Manual exposure acquisition (P. 35 )".
} The initial setting is "Auto" . From the next time, the system starts in
the mode selected when the power was turned OFF.
1
2
3
Exposure compensation
The exposure time specified by AE (Auto Exposure) can be
compensated. ("+ compensation" is available up to 1/6EV step
+ 1EV and "- compensation" is available up to 1/3EV step -2EV.)
When acquiring a dark specimen, perform "+ compensation" to make
the exposure time longer to bring the overexposed effect. When
acquiring a bright specimen, perform "- compensation" to make the
exposure time shorter to bring the underexposed effect.
Select the [Controller] tab
a
.
Press the
or button of [Exposure compensation]
b
or move
the bar
c
to set the exposure compensation values. The exposure
compensation value is displayed in
d
and the exposure time is in
e
respectively.
When Auto exposure mode is selected:
1
2
a
b
c
a
d
e
b