24
While operating the control box D2-CB,
if the power of the camera head is turned OFF:
Turn ON the main switch of the control box D2-CB to energize the
camera head.
While operating the control box D2-CB, if the interface cable is
disconnected by mistake, the power of the camera head is turned
OFF and it becomes the status that the camera head is not
connected, and an error message appears. In this case, press the
main switch of the control box D2-CB to terminate the system. Then,
connect the interface cable again and press the main switch of the
control box D2-CB to restart the system.
To Next Page
Loading...
