DP2-SAL
41
When a message appears, set the objective to the light path of the
microscope according to the message, and select [OK].
When a message appears, set the zoom/magnification changer to the
light path of the microscope according to the message, and select [OK].
When the next window appears, adjust the microscope optically
according to the message, and select [Next].
The next window appears to start acquiring the corrected image. When
the acquisition is completed, select [Next].
Repeat
4
to
7
until the correction of all combinations of objectives
and zoom/magnification changers selected in
3
is completed.
When the correction is completed, press the [Finish] button.
} If the wizard is cancelled in the middle, the corrected images
acquired so far are enabled and they are used for shading
correction in the acquisition.
Use the
a
button to select ON or OFF.
} While recording movies, the shading correction is OFF.
4
5
6
7
8
9
ON/OFF of shading correction while acquiring images
1
a
To Next Page
Loading...
