Chapter 3 Installation and Connection
41
HIGH FLOW INSUFFLATION UNIT UHI-4
For the other market
1. Remove the dust cap and plug from both ends of the cylinder hose
(MAJ-1080 only).
2. Inspect the cylinder hose for damage, cracks, and other irregularities. Use
the supplied wrench to attach the cylinder hose to the CO
2
gas inlet on the
rear panel of the UHI-4. Tighten with a force of 24.5 Nm (2.5 kgfm) (see
Figure 3.3).
Figure 3.3
3. When using the cylinder hose (PIN, MAJ-1080), attach the clamp to a gas
cylinder filled with CO
2
. Attach the clamp to the adapter by placing the pin of
the clamp into the guide hole of the cylinder and tighten the handle. Tighten
with a force of about 17.2 N
m (1.8 kgf/m) (see Figures 3.4 and 3.5).
Figure 3.4
Cylinder hose
Wrench
Pin
Yoke
Valve
To Next Page
Loading...
