17
EN
1
Getting started
Charging the batteries
NOTE
• The computer to which the recorder
is connected via USB must be on
for the batteries to charge. You
cannot charge the batteries when the
power of the computer is OFF, or the
computer is in standby, sleep or auto
power OFF mode.
• Do not use a USB hub when
charging the batteries by connecting
to the computer.
• You cannot charge the batteries
if [
]*
1
or [ ]*
2
is blinking.
Charge the batteries in an ambient
temperature of between 5 and 35°C
(41 and 95°F).
*1 [
] Ambient temperature is too
low.
*2 [
] Ambient temperature is too
high.
• If battery life has become noticeably
short on a full charge, replace the
batteries with new ones.
• Insert the USB connector securely
all the way. Operation will not be
normal if the connection is not made
properly.
• Use the supplied USB cable only.
Never use a third-party cable, as
this could damage the product. The
supplied cable should similarly never
be used for connections between
third-party devices.
• If charging does not start, select
[Storage Class] for [USB
Settings] > [USB Class] (☞ P.132).
• No audio will be recorded if the
batteries run out during recording.
Before starting recording, check that
the batteries are charged (☞ P.20).
To Next Page
Loading...
Need help?
General