© 2011 Omnicell, Inc. OmniRx Service Guide/67-2023 Rev F
OmniRx G4 Console Upgrade 4-3
Remove the G3 Sled
3. Disconnect the wireway cable from the J3 of the PowerCom3 Board
.
Figure 4-3. Disconnect the wireway cable from J3 of the PowerCom3 board
4. Disconnect the printer cable from J27 on the motherboard.
Figure 4-4. Disconnect the printer cable from J27 of the motherboard
5. Disconnect the fan power cable from J17 on the UPS board (if applicable).
To Next Page
Loading...
