3-76
Operation
One-direction function (bank number 1)
One-direction
function (bank
number 1, cam
number 1))
One-direction
function (bank
number 1, cam
number 32)
Use the mode selection switch to change to SET mode.
One-direction function setting
Up to cam number 16 for 3F88L-160.
One-direction function (bank number 2)
One-direction
function (bank
number 2, cam
number 1))
One-direction
function (bank
number 2, cam
number 32)
Up to cam number 16 for 3F88L-160.
One-direction function (bank number 8)
One-direction
function (bank
number 8, cam
number 1))
One-direction
function (bank
number 8, cam
number 32)
Up to cam number 16 for 3F88L-160.Up to bank number 4 for
720 resolution.
Bank selection
enabled status
One-direction function
setting enabled status
• Use the Bank/Function Key to set the one-direction function (Function No. F) and press the Set Key to
make the bank number flash in the Bank/Function display (bank selection enabled status). Use the Up
and Down Keys to set the bank number that contains the cam for which one-direction function is to be
set.
• Next, press the Set Key to display the cam number in the Cam/Parameter No. display. The present
settings will flash in the POSITION/OFF display (one-direction function setting enabled status).
• While the bank and cam numbers are displayed (one-direction function setting enabled status), press
the Cam/Parameter Key to change the cam number. Set the cam number for which the one-direction
function is to be set.
• Use the Up and Down Keys to set the data.
• Press the Set Key. The data will remain lit for approximately one second, the data will be confirmed,
and the display will start flashing again.
Operation Chapter 3
To Next Page
Loading...
