3-45
Operation ExplanationDisplay
SET
Press the Set Key to confirm the settings.
The setting will stop flashing for approximately 1 second and then
resume flashing.
Note When a setting is flashing, the Up and Down Keys are enabled
and the setting may be changed.
BANK/
FUN
Press the Bank/Function Key.
The display will return to only the function number that appears.
Turn OFF the power supply. (The settings will now be enabled.)
Note 1. The functions are enabled once the power has been turned OFF and then ON again.
Note 2. The display will change as shown below when the Bank/Function Key is pressed repeatedly
to set the function number.
Function level 0: 1→2→3→4→5→6→7→8→U→1→etc.
Function level 1: 1→2→3→4→5→6→7→8→A→t→U→1→etc.
Function level 2: 1→2→3→4→5→6→7→8→A→b→C→d→F→H→P→t→U→1→etc.
If the resolution selection (explained in the next section) is set to “1” (720 divisions/rotation),
“
5→6→7→8” will not be displayed.
3-6-2 Parameter List (SET Mode)
Bank/Func-
tion
Cam/Parame-
ter
Function name Setting
range
SPEED/ON POSITION/OFF
1 to 8
(1 to 4)
(see note 2)
0 Origin
compensation
absolute angle
--- Displays the
absolute angle for
origin compensation
(display only, no
settings can be
made).
---
1 to 32
(1 to 16)
(see note 1)
Program number
checking
--- Displays the number
of steps for the
displayed bank or
cam number
(display only, no
settings can be
made).
---
A (a)
1 Resolution
selection
0, 1 0: 360 divisions/
revolution (factory
setting)
1: 720 divisions/
revolution
---
Operation Chapter 3
To Next Page
Loading...
