1-8
1-3-1 Display Section
• Displays the operation status, error status, and settings data.
• The data displayed will differ depending on the mode.
Name Mode Display
1. Bank and function display
RUN Display the number of the operating bank.
PRGM Display the number of the bank being programmed.
SET Display the number of the function being set.
2. Cam and parameter
number display
RUN Displays “ru” when the START signal is ON and is blank
when the START signal is OFF.
PRGM Displays the number of the cam being programmed.
SET (Different for different settings functions.)
3. Number of revolutions and
RUN Displays the number of revolutions or an error message.
ON angle display
PRGM Displays the ON angle or an error message.
SET (Differs for different settings functions.)
4. Present angle and OFF
RUN Displays the present angle.
angle display
PRGM Displays the OFF angle.
SET (Different for different settings functions.)
1-3-2 Switches
Name Mode Function
5. Mode selection switch --- Switches between the three operation
modes: RUN, PRGM, and SET.
6. P ⋅ CLR switch PRGM Deletes all cam programs in the Cam
Positioner.
7. ADJ switch SET Adjusts the compensation by executing
origin compensation.
8. CW/CCW setting switch When power is turned ON Changes the rotation direction. The direc-
tion of increasing angle is set to either CW
(clockwise) or CCW (counterclockwise)
when viewed from the Resolver axle side.
Outline Chapter 1
To Next Page
Loading...
